10. Operating InstructionsOperating InstructionsSet the rocker switch to START.8712345Connect the battery to the charger using the correct cable.Check
Operating Instructions .11482697351
12. Front PanelFront PanelWhen a Non-Urgent Alarm is indicated the charge cycle has still completed and in most cases can be disregarded.When an Urgen
Front Panel .13Display when no battery connected or rocker switch set to STOP.Display whencharging.Display when chargecomplete.AMBER LED same as GREEN
14. Charge Configuration SettingsCharger Configuration SettingsCharge Profiles AvailableConventional IUIa/IEI.Opportunity charge.Amp Hr RangesConventiona
Charger AlarmsMain Switch. Urgent Alarm, shows the status of the front panel START/STOP rocker switch.Inlet Filter. Non-Urgent Alarm, can give warning
Module Over Temperature. Urgent Alarm, normally related to a blocked filter or restricted exhaust air or installation in an inappropriate location. Con
Battery Alarms .17Battery AlarmsOver Discharged Battery. Urgent Alarm, the battery is still under 1.9Vpc after 30 seconds of charge which indicates a
Finishing Charge Timeout. Non-Urgent Alarm, the battery has exceeded the maximum time allowed for the finishing part of the charge cycle. Generally not
Battery Alarms .19Maximum Cell Voltage. Non-Urgent Alarm, occurs when the voltage per cell exceeds the value set in the profile settings. Typically 2.7
WARNINGS2. WarningsKeep open flames away from batteries on charge.Risk of battery explosion.Be aware of battery fumes and electrolyte.Do not dispose of
20. TroubleshootingTroubleshootingProblem Possible Cause RemedyMain Switch Alarm.Front panel switch in the STOP position.Charge will start when the sw
Troubleshooting .21Problem Possible Cause RemedyOver Discharged Battery.Battery is <1.9Vpc at connection but recovers within 30 seconds of charge.
22. Exploded ViewExploded View
Spare Parts .23Spare PartsImage DescriptionMP130 ModuleMP330 Module3 Across Backplane AssemblySM31 Large Display AssemblyVoltage SensorMPC35 Main Boar
24. Spare PartsImage DescriptionMounting BracketCase FootFS3 CabinetFS3 LidFS3 Side PanelDC Output LoomBlanking Plate OvalBlanking Plate ConduitWelded
Maintenance .25MaintenanceProvided it is correctly installed in an appropriate location and is not abused, the charger will require little maintenance
26. Service & WarrantyService & WarrantyServiceIf both the RED and GREEN indicators are flashing there has been an Urgent Alarm that has preven
FS3 CabinetDimensions (in): 7.75W x 15.25D x 15.25HWeight: 46 pounds (with 3 modules) MP130 & MP330 ModulesAC Input MP130 MP330Single phase 20
Contents .3ContentsWarnings ...
4. LocationLocationThe preferred installation is where the charger(s) can be located on a shelf, protected against accidental contact with the lift tr
Mounting Bracket Options .5Mounting Bracket OptionsRear Mount1. Fix the mounting bracket to the wall using a typeof fastener that suits the wall mater
6. InstallationInstallationCharger Model NumberCharger ModulesSupply PhaseDC OutputSupply VoltageAC Supply in Max. Amps. Per PhaseAux. PlugBusbar Sele
AC Filter Board Configuration - Step 1 of 3AC Input Terminal BlockInstallation .7Configuration 1 - MP130 208-240V AC Single Phase.Configuration 4 - MP330
8. InstallationInstallationAUX power supply connection to 480V outlet J6.AUX power supply connection to 208-240V outlet J5.AC Input Busbar Selection T
FS3 Block Diagram .9FS3 Block Diagram
Kommentare zu diesen Handbüchern